-
Description
1. Installation and Wire Connection
1.1 Connect the 5-pin plug of the portable grinding head/handpiece to the OUTPUT socket at the main panel.
1.2 Connect the pedal switch to the FOOT SNV socket.
1.3 Select the proper drill bit according to actual requirements, and fasten it to the handpiece.
1.4 Turn the speed control knob to the left (M/N).
1.5 Connect with the main source power.
2. Operation
2.1 Press the function switch to HAND for manual control, the indicator will be on and the grinding head starts to moving slowly.
2.2 Turn the SPEED CONTROL to the right to accelerate the speed.
2.3 When the function switch is pressed to FOOT, step on the pedal and the machine starts. To work. (Foot switch is optional).
2.4 The turning directions can be swapped: FWD means clockwise direction and REV means counterclockwise direction.
2.5 Adjust the speed of the grinding head within a reasonable range.
2.6 Please adjust the handpiece to the lowest speed before changing forward/backward direction.
3. Specifications
3.1. Rated voltage range: 100-120v/60HZ, 220-240V/50HZ
3.2. Rated power input: 15W
3.3. Output rated voltage: DCO-12V
3.4. Rated speed: 0-30000RPM.
3.5. Main Part (power supply & control)
4. Instructions
4.1 Turn the SPEED CONTROL
counterclockwise to decelerate the grinding head to the minimum before turning off and switching on the main power source to 0.
4.2 After operation .put the grinding head on top of the main panel.
4.3 While the grinding head is in the operation, never pull off the 5-pin plug of the portable grinding head
4.4 for a long idle time, please disconnect the source power.
4.5 Any unauthorized disassembling of the products is prohibited. In case of any breakdown, please contact the agent or authorized repair center we promise swift, high-quality and
satisfactory service.
4.6 If the supply cord is damaged, it must be replaced by the manufacturer. It’s a service agent or similarity question in order to avoid a hazard.